How To Install Waterproof Cob Led Strip Lights In Wet Areas

Owing to their efficient use of power, enthusiasts are likely to come across COB – Chip on Board – LED strip lights. While fashionable and flexible, these strips come with a particular requirement when designing wet areas like a bathroom or outside a house. This article will provide you with step-by-step instructions to carefully and conveniently install weather-proof COB LED strip lights.

Regardless of the model chosen, users must take into consideration waterproofing IP ratings for their strip lighting systems. Most of these types of lights come with an IP rating which shows the level of moisture penetration resistance. In particular, for wet areas of use, an IP 65 rating or above is necessary, which allows the use of a strip in areas where water can get splashed on it, or the environment is dusty. Ensure that you always verify the specifications so that everything meets your expectations.

 Cutting and Connecting the Strips

Usually, COB LED strip lights have designated cutting areas that have small lines along the strip. With scissors, cut the strip to your desired length. Make sure compatible connectors are used if connecting more than one strip. Waterproof connections are very important to the durability of the light system in wet conditions. 

Mounting the COB LED Strip Lights

Because most of the waterproof COB LED strips have an adhesive that allows them to stick when peeled out of the package, mostly the installation is very easy. Just take the protective film off and stick it to a clean, dry surface by pressing it hard. To avoid moisture damage, it is important to have mounting clips or brackets that are held in position for upholding the strip. 

Connecting to Power

When the strips have been mounted, the next step is connecting them to the wire. It is equally important to use a waterproof power supply to avoid potential hazards. Wiring should also be done as directed by the manufacturer, as doing it contrary to the instructions can ruin the lights. It is always good to seek the help of a qualified electrician when in doubt regarding electrical connections.

Testing and Final Touchups

Once all the pieces are in place, switch the power on for testing the installation. Look for flickering or dim spots which are a sign for a bad connection. In case everything is fine, make the last adjustments in the orientation of the lights to ensure that the area is properly lit.  

Installing waterproof COB LED strip lights increases the aesthetic appeal and functionality of wet areas. If these steps are followed, installation can be done safely and effectively, and it will be durable. For waterproof COB LED strip lights and even professional help, visit the range of products that Lumimore has to offer. Enhance the way you light with our dependable and chic designs!